Tech-Protect Telefon - szkło ochronne - strona 10

Made of aluminum and glass, the camera lens caps from Tech-Protect Camring Fit+ are a very stylish way to protect this part of the device. The pads provide protection against scratches and breakage.

The set comes with a perfectly cut mounting frame, thanks to which you can position the glass perfectly. The manufacturer has simplified the installation method to such an extent that it is fully intuitive for every user.

Made of aluminum and glass, the camera lens caps from Tech-Protect Camring Fit+ are a very stylish way to protect this part of the device. The pads provide protection against scratches and breakage.

The set comes with a perfectly cut mounting frame, thanks to which you can position the glass perfectly. The manufacturer has simplified the installation method to such an extent that it is fully intuitive for every user.

Tech-Protect Glass Fit+ tempered glass is a high-quality protective accessory made of lightweight and precisely milled glass with a thickness of only 0.3mm.

The perfectly matched design fully preserves the sensitivity of the touchscreen. The manufacturer rates its hardness level at 9H on a ten-point scale, which translates into exceptional scratch resistance during everyday use.

The glass is characterized by crystal clarity, thanks to which it retains the natural colors and sharpness of the display. An additional advantage is a special oleophobic coating, which effectively minimizes the accumulation of fingerprints and other impurities on the surface of the glass, thus making it easier to keep it clean.

* Due to the various milling of the edges of the displays, after installing the film/protective glass on the screen, a slight air halo may be created around the screen! This is a natural situation and depends on the milling of the screen in a given piece.

INSTALLATION INSTRUCTIONS:
1) Start installation in the bathroom right after bathing - the water vapor will absorb all the dust from the atmosphere and it will not interfere with your installation.
2) Clean and degrease the surface of the screen thoroughly, then use a dry cloth to polish it to a shine.
3) Install the coating as evenly as you can - you can position it with two sheets, gluing them to the side of the device.
4) Get rid of air bubbles by pressing the whole thing down in a circular motion for a few dozen seconds. Do this so that the adhesive layer bonds to the screen as tightly as possible.